![]() ![]() the fact ive gone out my way to register to a forum and create my own post should speak for itself. I assume you did verify the model of your controller is one supported by the firmware update. There is almost nothing covering this issue on youtube and i still havent found anyone with a similar problem anywhere else. When do you get this message downloading it or running it If it comes up when running it, they proabably are looking for you to plug the controller into a USB port. Just to find out yet again it isnt working as i am met with a "ARGB controller detection failed press ok to try again" message. So i begin installing the firmware following the steps just as it says, "unplug all cables from argb controller", "plug in usb" ect. However the new rgb controller arrives today and is yet again not detected by master+, so i spend hours and hours looking for solutions to my problem and see that alot of people say i should download the firmware for the device. So i went to their website and bought the adressable rgb led small controller that was apparently compatible according to the website. So recently I bought a pack of 3 MF120 halo fans and found out that the included controller is not compatible with the cooler master rgb software. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |